![]() be aware that if you print that part thinner you are getting the part that pushes the shutter a little bit shorter and might have to adjust later. you might be able to print the part of the pusher that goes against the extruder a little thinner and try to use the stock screws, but since i had some laying arround i used them. To mount the pusher i took out 2 of the screws that are mounted to the right of the sprite extruder (those are m3 x 6mm) (look at pictures) and attached it with some m3 x 8mm. where i live that same model is the cheapest that i found online) The shutter, i used this one: (not an affiliate link, i do not live in the states nor EU so i did not buy it from that link. ![]() You will have to print the mount (BTshutterAdaptorEnder3s1.stl) and the pusher (pusher.stl).įor the adaptor i used prusaslicer: 0.4mm nozzle, 0.2 layer height, 3 walls, 4 top layers, 4 bottom layers, tree supports, zhop on (so i did not knock over the supports), and added 8mm of brim to the supports so they did not fell, also to remove the supports easier i put the top contact z distance of the supports at 0.15mm.įor the pusher i printed with 5mm of brim since is a very small piece and i didnt want to fall over, but print with watever settings you want. I needed a way to fix this shutter to the printer, as slick and nice looking the ender 3 s1 is, there arent any easy ways to fix it but i think i managed to create something useful.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |